Automatic Battery Charger Circuit

Automatic Battery Charger Circuit

Have you ever endeavored to diagram a battery charger which charges the battery thusly when battery voltage is underneath the predefined voltage? This article unveils you how to diagram a customized battery charger. This charger hence close off the charging system when battery accomplishes full charge. This keeps the significant charge of the battery. If the battery voltage is underneath the 12V, then circuit normally charges the battery.

Automatic Battery Charger Circuit Principle:

At the point when the battery voltage is underneath 12V, then the current from LM317 IC travels through the resistor R5 and diode D5 to the battery. Starting now zener diode D6 won't coordinate in light of the fact that battery takes all the current for charging. 

Exactly when the battery voltage rises to 13.5V, the present stream to the battery stops and zener diode gets the sufficient breakdown voltage and it allows the current through it. In the blink of an eye the base of the transistor gets the sufficient current to turn on so that the yield current from LM317 voltage controller is grounded through the transistor Q1. Along these lines Red Drove demonstrates the stacked with charge.

Circuit Components:

• 15-0-15V, 1A center tapped transformer
• LM317T voltage regulator
• 12V DC battery
• BD139 NPN transistor
• LED’s – red, green
• 8.2V zener diode
• 1n4007 diodes – 3
• electrolytic capacitor – 470uF
• pot – 10k
• resistors (1/2 watt) – 100, 240 ohms
• 2 Resistors – 1k
• Resistor – 2.2k
• connecting wires

Note:

The principle supply voltage 230V, 50Hz is joined with the essential twisting of the inside tapped transformer to venture down the voltage to 15-0-15V. 

The yield voltage of the battery charger ought to be under 1.5 seasons of the battery and the momentum of the charger ought to be 10% of the battery ebb and flow. Battery charger ought to have over voltage assurance, hamper and turned around extremity insurance.

(refference electronic hub )